Need help?Do you have a question about the B&G Triton Display and is the answer not in the manual?
General| Brand | B&G |
|---|---|
| Model | Triton Display |
| Category | Marine Equipment |
| Language | English |
Key technical details and requirements for NMEA 2000 networks.
Steps for planning and installing the NMEA 2000 backbone.
How to properly power the NMEA 2000 network.
Guides through the initial configuration process upon first power-on.
Options for resetting system configurations, network, and autopilot.
Automatically identifying and selecting data sources on the network.
Calibrating depth readings and setting the datum offset.
Calibrating the boat speed sensor for accurate log readings.
Calibrating boat speed using Speed Over Ground (SOG) from GPS.
Introduction to autopilot functionality when connected.
Essential procedures to perform before the autopilot is operational.
Setting boat type and drive voltage for system operation.
Detailed steps for calibrating rudder feedback for accurate readings.
Testing the rudder's response to autopilot commands.
Configuring rudder drive voltage, engagement, and motor output.
Adjusting rudder deadband to prevent hunting and optimize steering.
Performing sea trials to verify autopilot performance.
Automatically tuning steering parameters for optimal performance.
Fine-tuning steering parameters using response controls.
Selecting between high and low response parameter sets.
Addresses common problems and provides troubleshooting steps.
To Next Page
