Need help?Do you have a question about the B&G RAM T2 and is the answer not in the manual?
General| Brand | B&G |
|---|---|
| Model | RAM T2 |
| Category | Marine Equipment |
| Language | English |
Details the product's compliance with CE directives and radio communication standards.
Procedure for releasing the actuator from the steering quadrant in an emergency.
Guidance on steering the boat via autopilot controls during primary steering failure.
Explains the RAM T1/T2 hydraulic linear actuator's construction and basic operation.
Details hard over time and typical maximum thrust for RAM T1 and T2 models.
Data on hard over times, tiller arm lengths, rudder degrees, and typical max torque for model selection.
Instructions for fitting the tiller bolt to the steering quadrant, including torque specifications.
Guidance on mounting the actuator base, including suitable surface thickness and tightening torque.
Typical installation for an 8.4" radius quadrant with 70 degrees rudder angle.
Notes on clearance for pin removal and details of the electrical coil connections.
Recommendations for keeping the piston rod clear, avoiding salt water, and regular checks.
Information on seal kits, serial number ordering, and special tools for bleeding the unit.
Specifies the type of hydraulic fluid to use and warns against using brake fluid.
Guidance on initial setup, checking movement, and final inspection for damage or leaks.
Provides contact information for Simrad, B&G, and spare parts suppliers.
Instructions on responsible disposal of the unit at the end of its service life.
To Next Page
