Need help?Do you have a question about the B&G h1000 system and is the answer not in the manual?
General| Manufacturer | B&G |
|---|---|
| Display Type | LCD |
| Power Supply | 12V DC |
| Compass Integration | Yes |
| Wind Instrument Integration | Yes |
| Depth Sounder Integration | Yes |
| Speed Log Integration | Yes |
| Interfaces | NMEA 2000 |
| Radar Support | Yes |
| Chartplotter | Yes |
| GPS | Yes |
| Autopilot Integration | Yes |
| Storage Temperature | -20°C to 70°C |
Lists important safety warnings, including cleaning and potential radio interference.
Instructions on how to power up and shut down the h1000 system.
Setting alarm levels for wind speed, depth, course, and battery.
Details on setting and using a PIN for accessing calibration menus.
Guides on adjusting depth units, damping, and transducer offset.
Instructions for setting speed units, damping, and calibration factor.
Procedures for calibrating wind speed units, damping, and masthead unit offset.
Steps for setting compass heading offset, damping, and performing a swing.
Configuration of system-wide parameters like units, language, and diagnostics.
How the system responds to measured parameters exceeding set values.
Describes internal malfunctions or external inconsistencies causing errors.
Advises on avoiding interference and protecting connectors during installation.
Details the FastNet² connectors and pin assignments for power and data.
Specifies the duration of the product warranty and proof of purchase requirements.
To Next Page
