B&G Network DEPTH User Manual

CONTENTS
DEEP ALARM
GENERAL INTRODUCTION TO B&G NETWORK......... 2
ENABLING/DISABLING THE DEEP ALARM..................22
INTRODUCTION TO NETWORK QUAD......................... 3
ADJUSTING THE DEEP ALARM VALUE.......................22
EXAMPLE SYSTEMS USING NETWORK QUAD........... 4
ANCHOR ALARM
SELECTING THE DISPLAY MODE ................................ 5
USING THE ANCHOR ALARM.......................................23
ENABLING/DISABLING THE ANCHOR ALARM............24
USING THE SPEED KEY ................................................ 6
ADJUSTING THE ANCHOR ALARM SHALLOW LIMIT .25
CALIBRATION AND OPERATING PARAMETERS........ 7
ADJUSTING THE ANCHOR ALARM DEEP LIMIT.........25
SETTING THE DISPLAY DAMPING ............................... 8
SETTING THE SPEED AND LOG UNITS ....................... 9
USING THE TIMER/TEMP KEY .....................................26
SPEED AND LOG CALIBRATION ................................ 10
RESETTING THE TRIP LOG..........................................27
1 - MANUAL CALIBRATION - CAL ................................ 11
SETTING THE TIMERS AND LAP TIMER .....................28
2 - MANUAL CALIBRATION - LOG CAL........................ 12
SETTING THE TEMPERATURE UNITS.........................29
3 - AUTOMATIC CALIBRATION - AUTO CAL ............... 13
CALIBRATING THE TEMPERATURE SENSOR............30
RESETTING THE DEAD RECKONED DISTANCE ....... 15
USING THE LIGHTS KEY ..............................................31
USING THE DEPTH KEY .............................................. 16
NETWORK ALARMS .....................................................32
THE DEPTH DATUM - CAL ........................................... 17
FAULT AND ERROR MESSAGES .................................33
SETTING THE DEPTH DATUM..................................... 18
SETTING THE DEPTH UNITS....................................... 19
INSTALLATION..............................................................34
SITING THE UNIT...........................................................34
DEPTH ALARMS........................................................... 20
MOUNTING THE UNIT ...................................................34
SHALLOW ALARM
ENABLING/DISABLING THE SHALLOW ALARM ......... 21
SPECIFICATION ............................................................36
ADJUSTING THE SHALLOW ALARM VALUE .............. 21
610-HB-0503-05
1
www.bandgservice.co.uk

B&G Network DEPTH Specifications

General

Brand	B&G
Model	Network DEPTH
Category	Marine Equipment
Language	English

Summary

Using the Speed Key

Current Speed

Calibration and Operating Parameters

Display Damping, Units, and Calibration

Covers setting damping, speed/log units, manual and auto calibration.

Setting the Speed and Log Units

Speed and Log Calibration Methods

Manual Calibration (CAL)

Corrects displayed boat speed to a known measured speed.

Manual Calibration (LOG CAL)

Adjusts calibration figure for percentage error in log/speed.

Automatic Calibration (AUTO CAL)

Automatically calibrates and corrects boat speed and log.

Method 1: Manual Calibration - CAL

Method 2: Manual Calibration - LOG CAL

Method 3: Automatic Calibration - AUTO CAL

Depth Key Functions and Alarms

Water Depth Alarms (Shallow, Deep, Limits)

Configures and enables shallow, deep, and range-based depth alarms.

Setting the Depth Datum

Setting the Depth Units

Depth Alarms Overview

Shallow Alarm Configuration

Factory set and adjustable range for shallow water alarm.

Deep Alarm Configuration

Factory set and adjustable range for deep water alarm.

Anchor Alarm Configuration

Factory set and adjustable limits for anchor alarm.

Shallow Alarm Management

Deep Alarm Management

Using the Anchor Alarm

Anchor Alarm Management

Adjusting Anchor Alarm Limits

Setting Temperature Units

Calibrating the Temperature Sensor

Network Alarms Overview

Depth Alarm Display (Not Quad Unit)

Fault and Error Messages

Network Pilot Faults

Unit Internal Errors

Installation Guide

Siting the Unit

Mounting the Unit

Installation Data and Diagrams