Bandit47
MODEL 200 UC MAINTENANCE
MANUAL YOKE LIFT PROCEDURE
(FOR MACHINES WITHOUT HYDRAULIC YOKE LIFT)
Follow all pre-maintenance shut down procedures.
Make sure the machine hitch is securely coupled and locked to a tow vehicle.
Remove the yoke springs.
4. Remove the tongue jack and secure the jack to the yoke lifting mount as shown below. Must use a tongue
jack with a foot pad.
Crank the jack to raise the yoke and top wheel.
Do Not rely on the hand jack to hold the yoke and top wheel up.
Install the yoke lock pin completely and securely to help keep the top feedwheel in the raised position.
Crank the jack to lower the yoke and top wheel so the weight is on the yoke lock pin and not the jack.
Block and chain the top wheel up before doing any work inside throat
After the maintenance is complete, reverse the steps before putting the chipper back to work.
Slide Box Style Yoke Pivot Style Yoke
Before attempting any type of maintenance,
disengage clutch, wait for the disc to come to a complete
stop, turn o engine, remove the ignition key, make
sure the ignition key is in your possession, install the
disc lock pin, and disconnect the battery.
SAFETY INSTRUCTIONS
To Next Page
Loading...
