To Next PageTo Next Page
Need help?Do you have a question about the Bandit INTIMIDATOR 12XP/990 and is the answer not in the manual?
Warning about cancer and reproductive harm.
Identifies typical locations for serial and work order numbers.
Warning about diesel engine exhaust and its constituents.
Provides approximate dimensions and weights for models.
Critical safety step before servicing or removing guards/hoods.
Details the autofeed system, its operation, and settings.
Lists part numbers for autofeed digital tach hour meters.
Diagram showing the orientation of machine components.
Identifies controls and components with a diagram.
Checklist of steps before transporting the machine.
Procedures for safely loading and unloading the machine.
Details on operating the machine.
Procedures for preparing the work site and machine.
Steps for starting the engine and preparing for operation.
Details on required hydraulic fluid specifications and compatibility.
Lists replacement parts for chipper components.
Lists replacement parts for engine components.
Lists replacement parts for clutch components.
Diagram showing the orientation of machine components.
Instruction for installing knife bolts correctly.
Lists part numbers for knives and hardware.
Part breakdown for standard discharge units (pre-2/16).
Lists various discharge assemblies and their components.
Part numbers for the in-line hydraulic pressure check kit.
Hydraulic schematic without optional components.
Hydraulic schematic with optional components.
Explains the optional sliding tongue and its adjustment.
Details the optional heavy-duty lockable filler cap.
Exploded view and part list for the dynamic winch.
Diagram and part list for the hydraulic activated last chance system.
Exploded view of the hydraulic bump bar version 2.
Diagram and part list for the hydraulic tongue jack.
General information about Bandit controls for hand-fed chippers.
Lists primary control systems like Fuel Saver, Radio, Winch, Dump Valve, Bump Bar.
Details the main control panel display and starting procedures.
Explains system status, communication errors, and inputs/outputs.
Explains the Mode page for selecting operation modes.
Adjusting parameters and factory settings for the chipper.
Explains AutoFeed and Fuel Saver modes and settings.
Operation of feed assist with manual/electric winch functions.
Details options available in the popup and display menus.
Explains DPF regeneration modes and indicators.
How to view and interpret faults, messages, and LED indicators.
How to adjust service reminder intervals for engine maintenance.
How to view and interpret other engine parameters.
Notes on using engine service tools and disconnecting the controller.
Explains the Bump Bar and Bypass valve function for Feed Fwd.
Details for accessing and adjusting factory settings.
Notes on display, communication, engine faults, and feed behavior.
General
