Need help?Do you have a question about the Banner DXM Series and is the answer not in the manual?
Procedure for installing cable cord grips into the enclosure's pre-drilled holes for secure cable management.
Steps for wiring the lithium-iron phosphate battery to the DXM Controller's power terminals.
Instructions for installing the solar panel bracket and wiring the solar panel to the DXM Controller.
Overview of the DXM controller's features, capabilities, connectivity, and logic controller functions.
Details on the features of DXM100-A1 and DXM100-A2 controllers, including IIoT connectivity and radio options.
Comparison of different DXM100-Ax models, detailing their cellular carrier, ISM radio, and input/output capabilities.
Diagram and pinout description for the DXM100-Ax I/O base board, detailing connections and functions.
Guide to configuring the DXM100-Ax controller using the DXM Configuration Software.
Explains the traditional method of setting up DXM devices using the Configuration Software.
Example of configuring the DXM to read registers from an external Modbus Slave device.
Steps to create a new RTU read rule for fetching data from Modbus slave devices.
Procedure for setting the device's time zone and daylight saving options within the system settings.
Instructions for saving the XML configuration file and uploading it to the DXM device.
Specific configuration and binding instructions applicable only to DXM100-A2 models.
Procedure for binding the ISM radio and conducting a site survey for wireless network setup.
Steps to bind DX80 Nodes to a DXM Gateway and assign unique node addresses for network communication.
Guide to performing a site survey on the DXM to verify wireless communication and signal strength.
Instructions for activating the cellular data plan for the DEK Series Kit.
Steps to activate cellular services, including choosing a data plan and carrier.
Process for creating a user account for the Banner Cellular Data Portal.
Procedure to add the DEK kit device to the cellular network.
Guide to activating and setting up Banner Cloud Data Services for data visualization and alerts.
Steps to activate the cloud services account using an authorization code.
Procedure for creating a new gateway or monitoring site within the Banner Cloud Data Services.
Instructions on how to modify the XML configuration file using the DXM Configuration Software.
Steps to configure cloud data services settings, including push intervals and server details.
Process for uploading the configured XML file to the Banner Cloud Data Services website.
Procedure for installing the custom mounting plate to the enclosure for pole or wall mounting.
Guidance on mounting the solar panel at an appropriate angle for optimal performance.
Concluding remarks and resources for additional support, documentation, and contact information.
List of available documentation and resources for the DXM100-Ax family of products.
Important safety warnings regarding surge suppression, antenna use, and radio frequency emissions.
Details of the manufacturer's limited warranty for Banner Engineering products.
To Next Page
General