To Next Page
D
dustinsteinAug 13, 2025
Why do all counts reset overnight on my Banner Q45?
- SSusan RodriguezAug 13, 2025
The DXM Controller is programmed to reset all counts at 2 AM Central (observing DST).
Why do all counts reset overnight on my Banner Q45?
The DXM Controller is programmed to reset all counts at 2 AM Central (observing DST).
How to fix Banner Security Sensors when directional counts are not changing?
If the directional counts on your Banner Security Sensors are not changing, it could be due to a couple of reasons. First, the sensors may not be properly aligned, in which case you should realign them. Alternatively, the batteries might be low and need replacing. Try these two solutions to resolve the issue.
Why is the red LED flashing on my Banner Q45 Security Sensors?
If the red LED on your Banner Security Sensors is flashing, it indicates that the sensors are not communicating with the DXM Controller. To resolve this, try repositioning the DXM Controller to improve the radio signal.
What to do if the Operator Interface no longer displays the counts for Banner Security Sensors?
If the Operator Interface isn't displaying counts for your Banner Security Sensors, there are a few potential causes. It could be due to a delay after the DXM Controller was rebooted; allow up to 5 minutes for the counts to reappear and check the LED above the check mark button. Another reason might be a communication issue between the Operator Interface and the DXM Controller. Try moving them closer to each other to improve communication.
General| Type | Photoelectric Sensor |
|---|---|
| Supply Voltage | 10-30 V DC |
| Sensing Mode | Diffuse |
| Sensing Range | Up to 3 meters |
| Output Type | PNP or NPN |
| Connection Type | Cable or Connector |
| Protection Rating | IP67 |
