Banner SureCross DX80 Series - Analog Inputs, QT50 U Long-Range Ultrasonic Sensor; Analog Outputs; Analog Outputs, Three-Wire Sensors; Analog Outputs, Drive Motor Controllers

7.3.5 Analog Inputs, QT50U Long-Range Ultrasonic Sensor
QT50U Ultrasonic Sensor
sensor power (bn)
dc common (bu)
(wh)
(bk)
QT50U
A1−
GND
SP1
A1+
Four-wire QT50U sensor, using a FlexPower Node, and pow-
ered using the Node’s switch power terminal. The QT50U
output is set to 4–20 mA.
Do not apply power to the Ax+ connection.
7.4 Analog Outputs
7.4.1 Analog Outputs, Three-Wire Sensors
Powered from the SureCross Terminals
Powered Externally
AOx
GND
dc common
PWR
10-30V dc
sensor
AOx
GND
dc common
external power
sensor
Three-wire analog output device powered by the SureCross
device.
Three-wire analog output device powered externally (not
from the SureCross device).
7.4.2 Analog Outputs, Drive Motor Controllers
AI- Referenced to Ground
AI- Not Referenced to Ground
drive/motor
controller
AOx
GND
AI+
AI−
Drive/motor
controllers
AOx
GND
AI+
AI−
When the AI- can be referenced to ground, use this wiring
diagram for drive/motor controllers.
When the AI- cannot be referenced to ground, use this wir-
ing diagram for drive/motor controllers.
SureCross DX80 and Performance DX80 Product Manual
68 www.bannerengineering.com - tel: 763-544-3164 Rev. J