SureCross™ DX80 Quick Start Guide
P/N 128185 Rev A
Banner Engineering Corp. • Minneapolis, MN U.S.A.
www.bannerengineering.com • Tel: 763.544.3164
8
Quick Start: STEP 4
> Verify Communications, Gateway
Verify LED 1 is on and green.
Verify LED 1 is fl ashing Green and LED 2 is off. Until communication is established with the
Gateway, the Node’s LED 2 fl ashes Red. When communication is established, the Node’s
LED 1 fl ashes Green.
Status LED 1 LED 2
Power ON Green ON —
System Error Red Flash Red Flash
Modbus Communication Active — Yellow Flash
Modbus Communication Error — Red Flash
Status LED 1 LED 2
System Error Red Flash Red Flash (1 per sec)
RF Link Ok Green Flash (1 per sec) —
RF Link Error — Red Flash (1 per 3 sec)
> Verify Communications, Node
If testing the Gateway and Node before installation, verify the Gateway and Node are at
least two meters apart or the communications may fail.
To Next Page
Loading...
