Configurable Node with two selectable counter inputs, two selectable discrete inputs, and two discrete NMOS outputs
Features
IP67 Base
2.4 GHz
IP20 Base
900 MHz
The SureCross™ wireless system is a radio frequency network with integrated I/O that
can operate in most environments while eliminating the need for wiring runs. Systems
are built around a Gateway, which acts as the wireless network master device, and one
or more Nodes.
• Wireless industrial I/O device with two selectable discrete inputs, two selectable dis-
crete pulse counter inputs (rate or event; sinking, sourcing, or self-energized), and
two NMOS discrete outputs
• User selectable 10 kHz event counter(s) and/or 25 kHz rate counter
• FlexPower™ power options allows for +10 to 30V dc, solar, and battery power sour-
ces for low power applications.
• DIP switches for user configuration
• Frequency Hopping Spread Spectrum (FHSS) technology and Time Division Multi-
ple Access (TDMA) control architecture combine to ensure reliable data delivery
within the unlicensed Industrial, Scientific, and Medical (ISM) band
• Transceivers provide bidirectional communication between the Gateway and Node,
including fully acknowledged data transmission
• Lost RF links are detected and relevant outputs set to user-defined conditions
• The DX80...C models are certified for use in Class I, Division 2, Group A, B, C, D;
Zone 2 (Group IIC) Hazardous Locations when properly installed in accordance with
the National Electrical Code, the Canadian Electrical Code, LCIE/ATEX, or applica-
ble local codes/regulations (see Specifications)
For additional information, the most recent version of all documentation, and a complete list of accessories, refer to Banner Engineering's
website, www.bannerengineering.com/surecross.
Models
Model Frequency Environmental Rating I/O
DX80N9X2S4A2 900 MHz ISM Band
IP67, NEMA 6
Inputs: Two selectable discrete, two select-
able counter
Outputs: Two NMOS sinking discrete
DX80N2X2S4A2 2.4 GHz ISM Band
DX80N9X2S4A2C 900 MHz ISM Band IP20, NEMA 1
Class I, Division 2, Group A, B, C, D
Hazardous Locations (see Specifica-
tions)
DX80N2X2S4A2C 2.4 GHz ISM Band
Internal antenna models are also available. For more information, contact your local Banner Engineering Corp. representative.
WARNING: Not To Be Used for Personnel Protection
Never use this product as a sensing device for personnel protection. Doing so could lead to seri-
ous injury or death. This product does NOT include the self-checking redundant circuitry necessary to
allow its use in personnel safety applications. A sensor failure or malfunction can cause either an ener-
gized or de-energized sensor output condition.
SureCross DX80 FlexPower Node with Counter Inputs
P/N 136348 rev. G 1/13/2012
To Next Page
Need help?
General
