Banner SureCross DX80 - Wiring Diagrams

Wiring Diagrams
5-pin Euro-Style Hookup (Nodes)
Wiring the 5-pin Euro-style connector depends on the model and power requirements of the device.
Wire No. Wire Color 10 to 30V dc Powered Nodes Battery Powered Nodes
1 Brown 10 to 30V dc
2 White
3 Blue dc common (GND) dc common (GND)
4 Black
5 Gray 3.6 to 5.5V dc
Connecting dc power to the communication pins will cause permanent damage. For FlexPower devices, do not apply more than 5.5V to
the gray wire.
Terminal Block (IP67 Housing)
GND
PWR
AXN
GND
CI2
CI1
DO2
DO1
GND
PWR
AXP
GND
TIN
TIP
DI2
DI1
AXN, AXP. Not used. Do not make any wiring connections to these
terminals.
CIx. Counter IN x.
DIx. Discrete IN x.
DOx. Discrete OUT x.
GND. Ground/dc common connection.
PWR. Power, 10 to 30V dc power connection.
TIN, TIP. Not used. Do not make any wiring connections to these
terminals.
Ignore alternate labeling referring to other models that use this board.
DX80...C Wiring
Wiring power to the DX80...C models varies depending the power requirements of the model.
Terminal Label Gateway, DX85 * 10 to 30V dc Powered Nodes Battery Powered Nodes **
V+ 10 to 30V dc 10 to 30V dc
Tx/+ RS485 / D1 / B / +
V- dc common (GND) dc common (GND) dc common (GND)
Rx/- RS485 / D0 / A / -
B+ 3.6 to 5.5V dc
* Connecting dc power to the communication pins will cause permanent damage.
** For FlexPower devices, do not apply more than 5.5V to the gray wire.
SureCross DX80 FlexPower Node with Counter Inputs
P/N 136348 rev. G www.bannerengineering.com - tel: 763-544-3164 3