Baofeng G11S - Dual Watch function (TDR) - Menu 07; Power save (SAVE) - MENU 08; Time out Timer (TOT) - MENU 09

23
6.3.7 Dual Watch function (TDR) - Menu 07
This function is a dual-channel monitor scan, which can monitor the A and B segments in the normal mode. If a signal is
received on the monitoring channel, the scan stays on this channel. The steps for setting the dual-frequency waiting function
are as follows:
1> Press [MENU] key to enter the main menu, press [+UP]/[-DOWN] key to enter the MENU 07.
2> Press [MENU] key again to enter the TDR menu;
3> Press [+UP]/[-DOWN]key to select the dual-frequency wait switch, and the selection range is ON/OFF;
Note: OFF-turn off the dual watch function; ON-turn on the dual watch function.
Turn on the dual watch function; the screen will display the 'S' icon.
4> Press [MENU] key to confirm;
5> Press [PTT] or [A/B] key to exit the menu mode.
6.3.8 Power save (SAVE) - MENU 08
To save battery power, this function can turn off the transceiver when no signal is received.
1> Press [MENU] key to enter the main menu, press [+UP]/[-DOWN] key to enter the MENU 08.
2> Press [MENU] key again to enter the SAVE menu;
3> Press [+UP]/[-DOWN] key to select the power saving mode, and the selection range is ON/OFF;
Note: ON-turn on the power saving mode; OFF-turn off the power saving mode.
4> Press [MENU] key to confirm;
5> Press [PTT] or [A/B] key to exit the menu and return to normal operation mode.
6.3.9 Time out Timer (TOT) - MENU 09
The TOT function is used to prevent a too long transmission. This function temporarily blocks transmissions if the radio has
been used beyond the maxi- mum time permitted. Once reached the preset timer, the radio will be forced in reception mode.
The transmission time can be set in 6 levels with 30 seconds each (between 30 and 180 seconds). The setting steps are as
follows:
1> Press [MENU] key to enter the main menu, press [+UP]/[-DOWN] key to enter the MENU 09.