7
programming software:
Level 2 is set by default and has the lowest VOX sensitivity, 5 is the lowest one.
With the programming software you can enable/disable the VOX feature and select the sensitivity levels.
CPS programming path: Edit > VOX > VOX Level
Scan
1. Channel setting: 38 channel scan: ON
2. Walkie-talkie settings: the walkie-talkie is set to 38 channels, wait for 5S (no signal reception and transmission), then it will
enter the automatic scanning state, and the green light will flash
NOAA Weather Radio/Scan
Your radio has a NOAA WEATHER RADIO function, to enable the user to receive weather reports from designated NOAA
stations.
Your radio also has a NOAA WEATHER SCAN function, to enable the user to scan all 10 channels of the NOAA WEATHER
RADIO.
To turn the NOAA WEATHER SCAN on, Press and hold Channel Down (-) button to turn on the radio. The radio will go to WX
Band mode and start scanning all 10 channels and stop on any active channel. When the weather channel is scanning, the
red light will flash.
While in WX Band mode press the Channel Up (+)/ Down(-) buttons to select one of the 10 NOAA WEATHER (WX) BAND
channels.
To turn the NOAA WEATHER RADIO off, press the PTT button.
Squelch
The Squelch function suppresses noises on free channels and allows receiving even weak signals. The radio has 10 different
Squelch levels that can be set by programming software: 0 means that the Squelch is turned off; from level 1 to level 9 you
will have different levels of noise reduction. The higher is the level, the louder will be the Squelch. By default, the Squelch
level of radio is set on level 4. Make sure you do not set an excessively high squelch level because in this case you may not be
To Next Page
Loading...
