6
Channel Copy (Cable Copy)
Press and hold 【MONI】button to copy the channel parameters into another transceiver.
Before copying, connect the two transceivers by a copy cable. During the copy, red light of the copying
part continuously twinkles; green light of copied part continuously twinkles. Copying completed, indicator
lights go out. When copying is in progress, please release
【MONI】button.
Aging Test Program
Press
【PTT】and【MONI】button simultaneously to switch on the transceiver, aging test program begins
VOX Transmitting
Rotate channel selector at “No.9” , press and hold 【PF1】button to switch ON/OFF VOX transmitting.
VOX transmitting channel is for the entire channel (128 channels) opening or closing. (Note: PC software
VOX transmitting level must be set among Level1-10, VOX transmitting can be only valid. Factory setting
is Level 5.)
Roger (Ending Tone of Transmission)
Rotate channel selector at “No.12”, press and hold 【PF1】button to switch ON/OFF ending tone of
transmission.
Relayed Forwarding Confirmation
Rotate channel selector at “No.11”, press and hold 【PF1】button to switch ON/OFF confirmed tone via
Repeater.
Note: The details of PC programming software setting in communication via
OFF CTCSS DCS
STE(Tail Tone Elimination) ON ON ON
RP_STE (Tail tone elimination via repeater) ms OFF OFF OFF
Tail Tone Detection via repeater ms 400 400 600
Confirmation Switch via repeater ON ON ON
Confirmation Switch via repeater can operate manually, 【PF1】+ Channel 11 to switch ON/OFF.
Frequency Channel Report
To know the transmitting and receiving frequency of selected channel, and CTCSS of transmitting and
receiving, press and hold【MONI】to squelch, then press【PF1】.
Report order:
“Transmitting Storage”, Transmitting Frequency, Transmitting CTCSS. “ Receiving Storage”, receiving
frequency, receiving CTCSS.
After reporting the frequency, if DCS or CTCSS is not reported, it means no CTCSS is set in this channel.
Otherwise, continue to report DCS or CTCSS. While reporting frequency and CTCSS, a sound “Beep”
comes out, it indicates a “ frequency point”. After reporting DCS, a sound “Beep” indicates positive DCS,
while a sound “Beep, Beep” indicates reverse DCS.
High/ Low Power Switchover
With the state of FM radio unactivated, press【MONI】to make noise, then press 【PTT】 can
temporarily switch High/Low power of selected channel(selected by selector). Meanwhile report the state
of Dual Band Dual Watch Mode (TDR mode). If it is on, report “TDR ON”, it is off, report “TDR
OFF” .Voice prompt “Transmitting Power 1” is low power transmitting , “Transmitting Power 5” is high
power transmitting
MONI channel
With the dual standby state, keep holding 【MONI】button to take turns to monitor the signal of
designated channel and selected channel. If the green LED keeps lighting, the signal is from designated
channel, if the green LED twinkles, the signal is from selected channel.
PDF 文件使用 " pdf Fact or y Pr o" 试用版本创建 www. f i nepr i nt . cn
To Next Page
Loading...
