7
Scanning
The transceiver can scan group channel or full channels. The green LED twinkles rapidly while scanning.
Press and hold
【MONI】,【PF1】button simultaneously to start scanning group channel or full channels
Rotate the channel selector at “No.1”, after scanning; scanning channel No. is 1-16.
Rotate the channel selector at “No.2”, after scanning; scanning channel No. is 17-32.
The rest can be done in the same manner.
If rotate the channel selector at “No.16”, after scanning; scanning channels are 128 channels.
a. Press transmitting key of selected channel(【PTT】button). Under the time and carrier scanning
mode, it turns back to the current channel (selected by selector) and transmit, meanwhile stop
scanning. Under the search scanning mode, if a signal is scanned, also in the suspended scanning
state（green LED twinkles slowly）, then transmit in the current channel, otherwise it will turn back to
the current channel (selected by selector ) to transmit.
b. Press transmitting key of designated channel [Middle key], In the dual standby state, scanning
stops and go back to designated channel to transmit. Without dual standby state, transmitting is
invalid
c. Pressing [MONI] is invalid.
Scanning modes (scanning modes must be selected via PC programming software):
1. Under the time scanning mode, it would be paused for 5 seconds, then continue to scan after
scanning a signal.
2. Under the carrier scanning mode, scanning stops after a signal is scanned. And then continue
to scan after carrier signal lost for 3 seconds.
3. Under the search scanning mode, after scanning a signal, scanning pauses, the green LED
twinkles slowly, at this time press [PTT ] button, transmit only in the current scanned channel.
In the suspended scanning state, press [MONI] button to continue scanning (green LED
twinkles rapidly) until scan your desired channel. After scanning a signal, voice prompt the
scanned channel number.
FM Radio Function
In the single reception state, press [PF1] switch on FM radio. After FM Radio starts, press [PF1] to
search FM radio. Press [MONI] for FM band switch. If press [MONI], a sound “Beep” is heard, then FM
works in 65-75.9 FM band range, at this time press [PF1] radio frequency search in the range of
65-75.9MHz. If press [MONI] ,a sound “Beep, Beep” is heard, FM works in 76-108 FM band range, at
this time press [PF1] radio frequency search in the range of 76-108 MHz. Shutdown and restart or rotate
the selector can permanently turn off the radio.
Emergency Alarm
Press [MONI] twice rapidly and continuously, emergency alarm function starts. Alarm modes include
scene alarm, warning tone, warning codes (Must be selected by PC programming software). Alarm
channels are only selected channel.
Relay Forwarding Signal 1750 HZ
In the transmitting state, press [MONI] to send out 1750 HZ relay forwarding signal.
Chinese /English Switchover
Rotate the channel selector at “No.15”, press [PF1] to switch on the transceiver, then enter language
selection function, namely: Chinese /English Switchover
PTT ID Transmitting Way (must be set by PC programming software)
1. OFF
2. Press [PTT ] button to transmit BOT.
PDF 文件使用 " pdf Fact or y Pr o" 试用版本创建 www. f i nepr i nt . cn
To Next Page
Loading...
