6.3.5 Adding distilled water
(1) Get a certain amount of distilled water with a graduated container.
(2) Open all pouring caps of battery units.
(3) Absorb distilled water with ball type injector to charge the battery. When electrolyte
is over 15-20mm upper the plate, stop charging.
(4) After charging, tighten the pouring cap.
(5) Clean the surface of battery unit with a wet cloth.
Note:
(1) Wear eyes-protect glasses, rubber overshoes and rubber gloves.
(2) When adding the distilled water, never exceed the appointed amount. Adding
too much will lead the leakage of electrolyte, then the truck will be damaged when
charging or discharging.
(3) When adding too much, draw out water with ball type injector.
6.3.6 Charge the battery
(1) Precaution when charging
a. Each time after the battery is discharged, it should be charged in time. Don’t place
To Next Page
Loading...
