1640-IN-026-A-00 Page 1 of 10
Copyright © 1995 Barber-Colman Company
1640-IN-026-A-00
July 1995
MACO
®
4000, 5000 & 6000 Series
SPI Auxiliary Equipment Interface
Protocol
Instruction Manual
Table of Contents
1.0 Introduction.......................................................2
2.0 Setup Instructions ............................................2
2.1 Board Location .........................................2
2.2 Jumpers and Switches .............................2
2.3 Node Address ..........................................2
2.4 MACO Serial Communication Setup........2
2.4.1 Modfiles and Sample Screens .................2
2.4.2 COMM Setpoints......................................2
2.5 Wiring.......................................................3
2.6 Error Codes Screen .................................4
2.6.1 Baud Rate Setpoints ................................4
2.6.2 SPI Status Relays ....................................4
3.0 SPI Screens and RLD Programming ...............5
3.1.0 List of SPI Devices Supported .................5
3.1.1 Mold Temp Controller Commands ...........5
3.1.2 Chiller Commands ...................................5
3.1.3 Dryer Commands.....................................5
3.1.4 Loader Commands ..................................6
3.1.5 Melt Pump Commands ............................6
3.1.6 Additive Feeder Commands ....................6
3.1.7 Self-tune Temp Controller Commands ....6
3.1.8 General Purpose Temp Controller
Commands...............................................6
3.1.9 Robot Commands ....................................6
3.2 Setup Screen ...........................................7
4.0 Status and STM/MTS Control Relays ..............8
4.1 Status control relays ................................8
4.2 STM/MTS control relays ..........................9
4.2.1 Building the STM/MTS Table .....................9
5.0 SPI Status Monitor / setup screens...............10
To Next Page
Need help?
General