3737
Explosion areas
• Certain regulations restrict the use of radio equipment in
chemical plants, fuel depots and any site where blasting is
carried out. You are urged to comply with these regulations.
The terminal shall be protected by a specially fitted and
certified cover enabling use in proximity to a fuel pump
Electronic health appliances
• The handset is a radio transmitter which may interfere
with health appliances such as hearing aids, pacemakers,
hospital equipment, etc
• Your doctor or the equipment manufacturer will be able
to provide you with appropriate advice
External connection
• All external circuits connected to the Move/5000
must be SELV (Safety Extra Low Voltage) and LPS
(limited power source) within the meaning of section
2.2 and 2.5 of the standard IEC60950-1:2005+/A1:2010
and EN60950-1:2006+/A11:2009+/A1:2010+/ A12:2011
Cleaning
• To clean the terminal, use a soft cloth slightly moistened
with water. Do not clean the electrical connections, and do
not use solvents, detergents or abrasive products
The power supply contains the following symbols:
Double insulation symbol
Marking for Class II product. Such product does not
require a safety connection to electrical earth.
DC current output
This marking indicates that your terminal is suitable
for direct current (DC) only. It is completed by
afferent values (voltage, and max current).
AC current input
This marking indicates that the product operates
with an alternating current (AC) source (mains). It is
completed by afferent values (voltage, frequency,
max current).
+
–
DC power jack polarity
Output plug is positive (+) and the barrel (ring)
of the output plug is negative (-).
Indoor use only
VI
Energy star level 6
International efficiency marking protocol.
To Next Page
Loading...
