Barco AMM240ED - Page 18

R5912858 /05 AMM240ED18
Screen Control Menu
The available settings are:
• H Position: Adjust Screen H Position (Range 0 - 100)
11
• V Position: Adjust Screen V Position (Range 0 - 100)
11
• Frequency: Adjust Frequency (Range 0 - 100)
12
• Phase: Adjust Phase (Range 0 - 100)
12
• Noise Reduction: Adjust Noise Reduction (Range 0 - 31)
• Motion Offset: Adjust Motion Offset (Range 0 - 100)
Power Management Function
The monitor is equipped with a power management function, which automatically reduces the power
consumption when not in use in three power level modes.
• Standby Mode: The monitor goes into standby mode when the horizontal sync signal is off for about 10
seconds. In this mode, the screen goes off and the power LED blinks for 1 second On and 1 second Off.
The screen is displayed after the horizontal sync signal is restored.
• Suspend Mode: The monitor goes into suspend mode when the vertical sync signal is off for about 10
seconds. The power consumption during this is 10 W. In this mode, the screen goes off and the power LED
blinks for 1 second On and 1 second Off. The screen is displayed after the vertical sync signal is restored.
• Off Mode: The monitor goes into power-off mode when the vertical and horizontal sync signals are off for
about 10 seconds. In this mode, the screen goes off and the power LED blinks for 1 second On and 1
second Off. The screen is displayed after the vertical and horizontal sync signals are restored.
The AMM240ED power management system provides 4 phases of power saving modes by detecting the
horizontal sync signal as shown in the table below.
State
Normal Operation DPMS Standby DPMS Suspend
DPMS Off
Horizontal Sync Active Inactive Active Inactive
Vertical Sync Active Active Inactive Inactive
Video Active Blanked Blanked Blanked
Power Indicator Green Green flashing (1
sec. interval)
Green flashing (1
sec. interval)
Green flashing (1
sec. interval)
Power
Consumption
40 W 15 W 15 W 15 W
When the monitor is in power saving mode or detects an incorrect timing, the screen will be blank and the
power LED indicator will blink.
Preset Modes
Input Signal Timing
Resolution
Horizontal frequency
(KHz)
Vertical frequency (Hz) Pixel clock (MHz)
640 x 350 @70Hz 31.469 70.087 25.175
640 x 480 @60Hz 31.469 59.940 25.175
640 x 480 @75Hz 37.500 75.000 31.500
800 x 600 @56Hz 35.156 56.250 36.000
800 x 600 @60Hz 37.879 60.317 40.000
800 x 600 @75Hz 46.875 75.000 49.500
Advanced operation
11. Available for HD15, HD/SD SDI1 Component/RGBs
12. Available for HD15