2. Installation
Image 2-2
3. Connect the mains power input to a grounded power outlet.
Image 2-3
4. If necessary for your application, earth the MDRC-2222 by connecting the earth pin to a grounded
outlet by means of a yellow/green AWG18 wire (maximum a
dmitted cable length according to national
regulation requirements).
Image 2-4
5. Route all cables through the provided cable routing clip at the back of the display stand.
2.2 Display position a djustment
To adjust the display position
You can safely tilt, pivot, rai
se and lower the display as desired.
8
K5902146 (451920612622) EONIS 12/01/2018
To Next Page
Loading...
