Barco Eonis MDRC-2222 - Page 7

1. Welcome!
1. Display stand
2. Control wheel
- Pushlong(5sec):
o
to put display in standby mode
- Push short:
o
to exit standby mode
o
to active the OSD menu
o
to confirm selections in the OSD menu
- Turn clockwise
o
to scroll down in the OSD menu
o
to increase values in the OSD menu
- Turn counter clockwise
o
toscrollupintheOSDmenu
o
to decrease values in the OSD menu
3. Front sensor
4. Power status LED
- Off: Display not powered, or display is on but power LED function is disabled in OSD (see "Power
status LED", page 12)
- Steady green: Display operational
- Blinking green: Display is entering standby mode
- Steady orange: Display in standby mode
Back
8
9
1 2 3 4 6 75
Image 1-2
K5902146 (451920612622) EONIS 12/01/2018 5