31K5902142 /04 Nio 5MP
• Expert image source selection mode enables the dual input channel mechanism. This will make inputs
1 (DisplayPort 1 together with DVI 1) and inputs 2 (DisplayPort 2 together with DVI 2) to be handled as two
separate channels. Switching between channel 1 and channel 2 can in its turn be done automatically or
manually:
- Automatic channel selection will automatically detect the connected video input(s) and show it on the
screen. Priority will be given to channel 1 inputs if both channels have video input(s) connected. In this
way channel 2 can be seen as a backup channel.
- Manual channel selection allows to manually switch to either channel 1, channel 2 or no channel
(causing no input to be displayed).
For each channel, the video input (DisplayPort or DVI) can then also be selected automatically or
manually:
- Automatic input selection gives priority to DisplayPort over DVI for each channel.
- Manual input selection allows DisplayPort or DVI to be selected manually per channel.
To automatically detect the image source:
1. Bring up the OSD main menu.
2. Navigate to the Configuration > Image Sources menu.
3. Enter the Image Source Selection submenu and select Automatic.
To manually select an image source:
1. Bring up the OSD main menu.
2. Navigate to the Configuration > Image Sources menu.
3. Enter the Image Source Selection submenu and select One Image Source.
4. Enter the Image Source submenu and select one of the image sources.
To enable expert mode (dual input channel mechanism):
1. Bring up the OSD main menu.
2. Navigate to the Configuration > Image Sources menu.
3. Enter the Image Source Selection submenu and select Expert.
To automatically switch between the input channels:
1. Bring up the OSD main menu.
2. Navigate to the Configuration > Image Sources menu.
3. Enter the Image Source Selection submenu and select Expert.
4. Enter the Automatic Selection of Input submenu and select Enabled.
To manually switch between the input channels:
1. Bring up the OSD main menu.
2. Navigate to the Configuration > Image Sources menu.
3. Enter the Image Source Selection submenu and select Expert.
4. Enter the Automatic Selection of Input submenu and select Disabled.
5. Enter the Left submenu and select one of the input channels.
To select the image source on channel 1 and 2:
1. Bring up the OSD main menu.
2. Navigate to the Configuration > Image Sources menu.
Advanced operation
To Next Page
Loading...
