Barco RLM W8 - Error Debugging Methods

- 26 -
Please follow below three kinds of error debugging to get error code:
z Use RS-232 command to get error code for debugging, please kindly refer to Page 45 (RS-232
Communication) for set-up and debugging.
z Use web browser (RJ-45) to get error code for debugging. The web browser can be used to check
the error code and root cause of the problem. The web browser set up configuration is as below,
please press “Diagnostics” – “Advanced Diagnostics” to get error code as below interface mark:
z Use Projector toolset to get error code for debugging. Projector toolset can also be used to trouble
shoot the projector.