- 39 -
1-7. Click “Upgrade SW” to start the firmware upgrades process. Prior to the firmware
upgrade process, you will be prompted with a warning dialog box for confirmation and click
“Yes” to proceed the firmware upgrade process.
1-8. The firmware upgrade process indicator of Micro-Control board (The 1
st
part of this
firmware upgrade process) will be shown as follows,
1-9. After finishing the firmware upgrade of the Micro-Control board (1
st
part), the firmware
upgrade process of the video board (2
nd
part) will be started after then. A DOS command box
with the ISP program will be activated and shown as follows,
To Next Page
Loading...
