- 40 -
1-10. Depending on the file size of the firmware, it may take about 12 ~ 25 minutes before the
firmware upgrading can be finished. The following dialog box will be shown after finishing the
firmware upgrade process. Click “OK” button and “Exit” from the menu to exit from the whole
firmware upgrade process.
1-11. After finishing the firmware upgrade process, please recycle the AC power.
2. Firmware downloads procedure for sxW2 part:
2-1. Connect the AC power of the projector and have the projector in standby mode.
2-2. Connect the RS-232 cable between the projector and the PC.
2-3. Open a terminal program (e.g. Tera Term) with the following setting, baud rate 38400,
Databit: 8, Parity: none, Stop: 1 bit, Flow control: none.
To Next Page
Loading...
