Manual 2100-365
Page 11
FIGURE 3
COMBUSTIBLE CLEARANCE
FOR WG24, WG30 AND WG36 MODELS
FIGURE 3A
COMBUSTIBLE CLEARANCE
FOR WG42, WG48 AND WG60 MODELS
WARNING
A
minimum
of one (1) inch clearance must be maintained between the supply air duct and
combustible materials. This is required for the first three (3) feet of ducting.
It is important to insure that the one (1) inch minimum spacing is maintained at all points.
Failure to do this could result in overheating the combustible material and may result in a fire causing
damage, injury or death.
MIS-1682
MIS-1714
To Next Page
