CT12A INSTRUCTION MANUAL
56-101-03100-E TOC
May
/ 29 / 09
Page xiv
TABLE OF CONTENTS
Contact Information
Attention Page
Disclaimer Page
Revision Record Page
List of Approved Repair Facilities
Table of Contents
List of Figures and Tables
CHAPTER ............................................................................................PAGE
INTRODUCTION
1. PUBLICATION BREAKDOWN .....................................................................1
2. INFORMATION PROVIDED WITH THE UNIT.............................................1
3. RECERTIFICATION .....................................................................................3
4. APPLICABILITY ...........................................................................................3
1 PRODUCT DESCRIPTION
1. PRODUCT SCOPE ......................................................................................5
2. CT12A FEATURES ......................................................................................6
3. PHYSICAL DESCRIPTION ..........................................................................6
2 PRODUCT SPECIFICATIONS
1. PHYSICAL DATA .........................................................................................9
2. POWER CHARACTERISTICS .....................................................................9
3. TEMPERATURE CHARACTERISTICS .......................................................9
4. CABLE APPLICABILITY...............................................................................9
5. TOLERANCES FOR TENSION MEASUREMENT.......................................9
6. SPECIFICATIONS FOR CT12A MODEL NUMBERS .................................10
3 OPERATION
1. DETERMINING THE UNIT CONFIGURATION...........................................11
2. POWERING ON THE UNIT AND INTRODUCTORY DISPLAY ..................11
3. SELECTION OF THE OPERATING MODE ................................................11
4. TAKING A TEMPERATURE READING ......................................................12
5. SETTING THE DISPLAY BACKLIGHT .......................................................12
6. SETUP OF CT12A FOR TAKING TENSION MEASUREMENTS ...............13
7. TAKING TENSION MEASUREMENTS.......................................................14
8 HOLDING A TENSION MEASUREMENT...................................................16
9. USE OF THE VERIFICATION BAR ............................................................16
10. POWERING OFF THE CT12A ....................................................................18
11. RECHARGING THE CT12A BATTERY ......................................................18
4 RECEIVING, SHIPPING, AND STORAGE
1. RECEIVING.................................................................................................19
2. SHIPPING ...................................................................................................19
3. STORAGE ...................................................................................................19
To Next Page
Loading...