2. Press the SCROLL button until display
reads, “tGt.”
3. Press the UP or DOWN button to set
the target setpoint temperature.
Running a Program (8
Segment Programmable
Models)
To run a program, press the RUN/HOLD but-
ton. (The RUN light will illuminate.)
Running a Program (4x16
Segment Programmable
Models)
To run a program, press the RUN/HOLD but-
ton. (The RUN light will illuminate) or:
1. Press the PAGE button until you
reach the run list (run LiSt).
2. Press the SCROLL button until display
reads, “PrG.”
3. Press the UP or DOWN button to
select the program number you want
to run.
4. Press the RUN/HOLD button once to
start the program. (The RUN light will
illuminate.)
34
8 SEGMENT & 4
X16 SEGMENT
PROGRAMMABLE MODELS W/OTP
To Next Page
Loading...
