33
3. Press the UP or DOWN button until dis-
play reads, “cALL.”
4. Press the SCROLL button until display
reads, “PrG.n.”
5. Press the UP or DOWN button to select
a program number to be linked.
6. Press the SCROLL button until display
reads, “CYC.n.”
7. Press the UP or DOWN button to select
the number of cycles the linked program
is to be run.
End
To end or repeat a program:
1. Press the PAGE button until you reach
the program list (ProG LiSt).
2. Press the SCROLL button until display
reads, “tYPE.”
3. Press the UP or DOWN button until dis-
play reads, “End.”
4. Press the SCROLL button until display
reads, “End.t.”
5. Press the UP or DOWN button to toggle
between “dwEll” (an indefinite dwell), “S
OP” (End Segment Output Power) and
“rSET” (reset).
Setting the Target Setpoint (4x16
Segment Programmable Models Only)
1. Press the PAGE button until you reach
the program list (ProG LiSt).
8 S
EGMENT & 4
X16 SEGMENT
PROGRAMMABLE MODELS W/OTP
To Next Page
Loading...
