32
4. Press the SCROLL button until dis-
play reads, “dur.”
5. Press the UP or DOWN button to
select a time in dwell units (seconds,
minutes or hours; set in the “dwL.U”
parameter).
StEP
To climb instantaneously from the current
temperature to a specified temperature.
1. Press the PAGE button until you
reach the program list (ProG LiSt).
2. Press the SCROLL button until dis-
play reads, tYPE.”
3. Press the UP or DOWN button until
the display reads, “StEP.”
4. Press the SCROLL button until dis-
play reads, “tGt.”
5. Press the UP or DOWN button to set
a target setpoint.
cALL (Running Multiple Programs; 4x16
Segment Programmable Models Only)
To call a program as a subroutine:
If you want to run multiple programs, you can
program the controller to “call” or link one pro-
gram to another. This makes it possible to run
one program at any time during another pro-
gram and also return to the original program if
desired.
1. Press the PAGE button until you
reach the program list (ProG LiSt).
2. Press the SCROLL button until dis-
play reads, “tYPE.”
8 S
EGMENT & 4
X16 SEGMENT
PROGRAMMABLE MODELS W/OTP
To Next Page
Loading...
