10
Site Selection
Install furnace on a sturdy surface and allow adequate
space for ventilation.
The electrical specifications are located on the specifica-
tion plate on the back of the furnace. Consult Barnstead
International if your electrical service is different than
those listed on the specification plate. Prior to connecting
your Type F62700 furnace to your electrical supply, be
sure the front power switch is in the “OFF” position.
Installation
Caution
Be sure ambient temperature does not
exceed 104°F (40°C). Ambients
above this level may result in damage
to the controller. Allow at least six
inches of space between the furnace
and any combustible surface. This
permits the heat from the surface case
to escape so as not to create a possi-
ble fire hazard.
Warning
Do not use in the presence of flamma-
ble or combustible chemicals. Fire or
explosion may result; this device con-
tains components which may ignite
such materials.
Warning
To avoid burns, this furnace must not
be touched on the exterior or interior
furnace surfaces during use or for a
period of time after use.
To Next Page
Loading...
