To View the % Output Power
From the HOME DISPLAY press the SCROLL button
twice. Press and release the UP or DOWN button to view
the % output power. This value is a read-only value and
cannot be changed.
Controller Parameters
Home display
°C: Temperature units in Celsius. Temperature units can
not be changed without entering the configuration.
Contact Customer Service if a different temperature unit
is required.
OP: % output power demand.
IdHi: Deviation high alarm.
Al List
IdHi: Deviation high alarm.
Atun List
tunE: One-shot autotune enable.
Pid List
Pb: Proportional band (in display units).
ti: Integral time in seconds.
td: Derivative time in seconds.
ACCS List Code: Access code (Code needed to enter or
change the other configuration parameters which are not
normally accessible.) Not accessible.
14
SINGLE S
ETPOINT MODEL W
/OTP
To Next Page
Loading...