Barnstead F62730 - Programmable Controller Program Management; Running, Holding, and Cancelling Programs

30
End
To end or repeat a program:
1. Press the PAGE button until you reach the pro-
gram list (ProG LiSt).
2. Press the SCROLL button until display reads,
“tYPE.”
3. Press the UP or DOWN button until display
reads, “End.”
4. Press the SCROLL button until display reads,
“End.t.”
5. Press the UP or DOWN button to toggle
between “dwEll” (an indefinite dwell), “S OP”
(End Segment Output Power) and “rSET”
(reset).
Running a Program (8 Segment
Programmable Models)
To run a program, press the RUN/HOLD button. (The
RUN light will illuminate.)
Holding a Program
To put a running program on hold, press the RUN/HOLD
button. (The HOLD light will illuminate.)
Cancelling a Program
To cancel a program, hold the RUN/HOLD button down
until the RUN and HOLD lights go off.
8 SEGMENT P
ROGRAMMABLE MODEL W
/OTP