ex
6 Configuration
Subject to technical modifications
Revision A / 04/2019
57 / 106
The barcode can be recreated using the Zebra 123Scan tool in case the barcode is damaged or
detached.
The required MAC address can be found on the type lable of the base station.
Pairing - Method 2
With this method, the scanner automatically connects to the contacts when inserted into the base
station.
It is not necessary to scan the base station barcode.
If the pairing is successful, a low/high connection beep will sound a few seconds after the digital
scanner is inserted into the docking station. More audio sequences can be found in the Zebra "Product
Reference Guide" under Definitions for the Wireless Beeper.
In the default settings, pairing via the base station contacts (Enable Pair on Contacts) is enabled.
Enable Pair On Contacts
Default = activated (Enabled)
Disable Pair on Contacts
Table 47 Pairing barcodes for the connection to the base station
If the BCS 3678
ex
is paired with other Bluetooth devices (not with the base station) we recommend
to deactivate the function "Pair on Contacts". Otherwise the BCS 3678
ex
may establish the
connection with the base station. This will delete the connection with other Bluetooth devices.
To Next Page
Loading...
Need help?
General
