Tech 400 User Guide R5 4/1/08
12
Tech 400 User Guide R5 4/1/08
17
Main Menu Settings Menu
This is the main screen- providing acce
ss to the main functional
items of the Tech 400.
When this is selected, the next screen gives settings options
The options are as follows:-
• W
heels To Test: - Select ‘1 wheel’ or ‘4 wheel’ test
The default entry position is page 1- select by vehicle (indicated
by
1/6 in the status line)
• TPM
ID – Select between Hexadecimal ID display or
Decimal ID display
• Pres
sure – Select between ‘PSI’, ‘kPA, or ‘Bar’ pressure
display
1. Selec
t by Vehicle
This Item is a sub menu, pressing the Enter Key will take the
us
er to the “Select by Vehicle” menu. The user should
select the vehicle make, model and year.
• Lang:
- Select language (supports English by default)
• Tem
perature: - Select between Celsius (°C) or Fahrenheit
(°F)
• Di
splay Contrast – Select value that gives best display
contrast
2. Vi
ew TPM Data
This item is a sub menu, pressing the Enter Key will take the
us
er to the results screens. Press direction arrows to examine
the required results. In 4 wheel mode, each TPM has wheel
locations of LF; Left Front; RF; Right front; RR; Right rear; LR;
left rear.
Press ‘Enter’ to select and change the units for the selected
parameter.
3. Delete TPM
Data
Pressing the enter key will delete stored TPM results data.
4. Sett
ings
This item is a sub menu, pressing the Enter Key will take the
u
ser to the settings menu. This menu is on screen 4- not
shown on the screen above, but found using the ‘up’ or
‘down’ keys
5. Curr
ent TPM or vehicle selection
To Next Page
Loading...
