Bartec MAK TIGER 3003

Other manuals for Bartec MAK TIGER 3003

Service Manual216 pages

Questions and Answers

A
Amy HouseJul 25, 2025
What to do if the ERROR LED is flashing and the Bartec Measuring Instruments printer won't print?
- C
  Carl JohnsonJul 26, 2025
  If the ERROR LED is flashing and your Bartec Measuring Instruments printer won't print, there are a few potential causes. First, turn the printer off and check for a paper jam. If there's no jam, the printhead may have overheated; in that case, the printer will resume printing once it cools down, usually within a few minutes. If neither of those issues is present, try switching the printer off and then on again after about 10 seconds.
J
Jennifer DayJul 29, 2025
What to do if there is a paper jam in the Bartec Measuring Instruments printer?
- D
  Douglas SinghJul 29, 2025
  If there is a paper jam in your Bartec Measuring Instruments printer, switch the printer off and press the button to open the cover. Remove the jammed paper, put the roll back in the printer, and close the cover. If paper is caught in the automatic cutter and the printer cover won't open, then open the cover on the cutter.
X
xhullAug 3, 2025
What to do if the ERROR LED is on and the Bartec Measuring Instruments printer will not print?
- M
  Mr. Patrick LozanoAug 3, 2025
  If the ERROR LED is on (not flashing) and your Bartec Measuring Instruments printer won't print, check the PAPER OUT LED. If the PAPER OUT LED is on, fit a new roll of paper. If the PAPER OUT LED is not on, make sure that the printer cover is closed properly by pressing it down until it clicks into place.
B
Brian GarrettAug 7, 2025
Why is the print quality poor on my Bartec Measuring Instruments?
- G
  Gloria BennettAug 7, 2025
  Poor print quality on your Bartec Measuring Instruments may be due to dust or lint on the heating element of the thermal printhead. Try cleaning the printhead.
D
Dylan FergusonAug 11, 2025
What to do if the paper cutter is blocked in my Bartec Measuring Instruments printer?
- M
  Melissa CaldwellAug 11, 2025
  If the paper cutter is blocked in your Bartec Measuring Instruments printer because a foreign object, such as a drawing pin or paper clip, has fallen into it, the printer will enter an error state and automatically start a recovery process. If the cutter does not automatically return to its normal position, then follow the instructions to remedy the problem.
C
Cole AlvaradoAug 16, 2025
What to do if the ERROR LED is not on but the Bartec Measuring Instruments printer will not print?
- A
  Adam CohenAug 16, 2025
  If the ERROR LED is not illuminated, but your Bartec Measuring Instruments printer refuses to print, try running a self-test to ensure the printer is functioning correctly. If the self-test passes, verify the cable connections at both ends. If the printer continues to not print, contact your after-sales service center or consider replacing the printer.
K
Katherine HarrisAug 20, 2025
How to troubleshoot LEDs not lighting up on Bartec Measuring Instruments control panel?
- J
  jesus63Aug 20, 2025
  If the LEDs on the control panel of your Bartec Measuring Instruments are not lighting up, make sure that the cable is correctly connected and check that power is being supplied to the entire system.