Tour menu
51
MAK 3003 Measuring system TIGER / LYNX Operating Instructions, Software version 2.35, BA 190130 (11.07.2022)
12.1 Intake
To change intake data, you can call up the intake dialogue manually.
12.2 Pump over measured
During the tour it may be necessary to pump milk, e.g., over to a trailer to get
free tank capacity for further intakes. The pumping over can be measured or
unmeasured (see section 12.5).
If you want to record the quantity pumped over, select "Pump over measured"
in the tour menu.
● If required, you can enter a pump-over ID; you can specify the pump-over
volume as a preset quantity.
For pumping over, fixed pump-over IDs can also be stored in the configuration.
This allows the same pump-over ID to be transferred at different pump-over
locations.
● Start the pump-over by confirming the entries with the soft key CONFIRM .
To Next Page
Loading...
