Safety Precautions
6
MAK 3003 Measuring system TIGER / LYNX Operating Instructions, Software version 2.35, BA 190130 (11.07.2022)
2 Safety Precautions
The system operator is responsible for all complying with all regulations appli-
cable to the storage, transport and handling of the food product "milk".
All regulations and provisions remain in full force when operating the system
with MAK devices.
MAK devices are built in compliance with applicable regulations and must
leave the factory in perfect condition. The devices must be installed and ser-
viced by qualified technicians.
Make sure that the information and operating conditions listed by the man-
ufacturer are followed.
Follow the instructions on operating and servicing the devices.
If you notice any damage or deterioration on parts of the system or if safe
operation is not ensured for other reasons, do not start up the system or
shut it off immediately. Notify your service point.
You should also contact our service technicians if you notify malfunctions
or defects during operation or have any doubts as to whether the devices
are working property.
The measuring system may only be operated for applications that are subject
to legal metrological control in the respective EU member state if the nominal
operating conditions specified in the EU-type examination certificate are met.
The controller software is constantly evolving. A different software version or
configuration may cause the screen displays on your system to differ slightly
from the illustrations in this document.
To Next Page
Loading...
Need help?
General
