Enter supplier number
16
MAK 3003 Measuring system TIGER / LYNX Operating Instructions, Software version 2.35, BA 190130 (11.07.2022)
6.2 Supplier recording with GPS
If the vehicle stops at a position within a tour for which supplier data are stored
in the database, these data are automatically displayed.
The requirement for this is that an intake has already been carried out at this
location with the corresponding supplier number. The supplier number must
be manually input once (see section 6.1). It is then automatically saved and
assigned to the location.
Supplier selection
If several suppliers are stored under one location, you can use the selection
keys on the controller to select a supplier.
To Next Page
Loading...
