Upper Threshold Moisture Sensor-Based Watering
Taking a biSensor Reading and Manually Entering the Upper Threshold
1. Pour at least two gallons of water directly over the spot where the sensor is buried.
2. Temporarily disable the program so the area won’t be watered for at least 24 hours:
a. On the BaseStation 1000 controller, press the Program Setup button. The Program Setup menu
displays.
b. Press the PRG button until the program that you set up to water based on biSensor readings
displays in the upper-left corner of the screen.
Note: To move backwards in the list of programs, press and hold the PRG button, and then press
the – button repeatedly.
c. Press the
button to highlight the Enable/Disable option, and then press the OK button.
d. Press the OK button to remove the check mark from the Enabled field.
3. Wait 24 hours from the time when you saturated the sensor.
4. On the BaseStation 1000 controller, press the Test button. The Test menu displays.
5. Press the
or
button to highlight the Test Moisture
Sensor option, and then press the OK button. The Test
Moisture Sensor screen displays.
6. Press the
or
button to select the biSensor that is
installed in the landscape.
7. Press the OK button to test the biSensor.
Note: If any zones or programs are running when the
test is activated, watering will pause for 10 minutes. The test results display the moisture
percentage.
8. Write down the moisture reading.
9. Press the Program Setup button. The Program Setup menu displays.
10. Make sure that the program that you set up to water based on biSensor readings displays in the
upper-left corner of the screen. If it doesn’t, press the PRG button until the correct program
displays.
Note: To move backwards in the list of programs, press and hold the PRG button, and then press
the – button repeatedly.
11. Press the
button to highlight the Setup Prg. Stop option, and then press the OK button. The Setup
Prg. Stop screen displays the list of stop conditions.
12. Press the
button to highlight the Moisture Stop option, and then press the OK button. A
checkmark displays next to the Moisture Stop option.
Baseline Support: 866-294-5847 7 www.baselinesystems.com
To Next Page
Loading...
Need help?
General