Why is the status LED not lit on my Basler Vision Technologies Digital Camera?
If you are experiencing a situation where the status LED on the back of your Basler Vision Technologies Digital Camera is not lit, it could be due to insufficient power. Ensure that the camera is receiving adequate power, paying attention to Section 2.8, which outlines the maximum input voltage.
What to do if Basler Vision Technologies Digital Camera is not detecting an ExSync signal?
If your Basler Vision Technologies Digital Camera isn't detecting an ExSync signal, verify the ExSync signal integrity. Alternatively, configure the camera to operate in Free run mode.
What to do if there is no image from Basler Vision Technologies Digital Camera?
If you're not getting any image when attempting to capture one with your frame grabber using the Basler Vision Technologies Digital Camera, check the camera's power source with a voltmeter. The output should be 12 VDC ± 1.2 V.
How to fix 3 flashes on Basler Vision Technologies Digital Camera?
If your Basler Vision Technologies Digital Camera is flashing 3 times, and you are not using an external sync signal, this is normal. If you are using an ExSync signal, inspect the cable and the ExSync generating device.
General| Frame Rate | 30 fps |
|---|---|
| Sensor Type | CCD |
| Interface | Camera Link |
| Shutter Type | Global Shutter |
| Lens Mount | C-Mount |
| Bit Depth | 8/10 bit |
| Operating Temperature | 0 °C - 50 °C |
To Next Page