Basler Vision Technologies A202k - Mirror Image

Configuring the Camera
4-20 BASLER A202
k
DRAFT
4.2.4.16 Mirror Image
Purpose: To enable or disable the mirror image feature. See Section 3.9 for an explanation of mirror
image.
Type: This is a read or write command.
Read Command: Cmd-ID R/W-Flag Data Length Data
0xC1 1 1 -
Response: Cmd-ID R/W-Flag Data Length Data
0xC1 0 1 1 Byte
Write Command: Cmd-ID R/W-Flag Data Length Data
0xC1 0 1 1 Byte
Response: None
Data Format: Byte 1 An ID that specifies the mirror image status
(see the table below).
ID Mirror Image
0x00 Mirror image not enabled
0x01 Mirror image enabled