Installation Guide
Basler IP Camera 15
LanguageLanguageLanguageLanguageLanguageLanguageLanguageLanguage
5. Obtain the 6-pin Phoenix plug that is included with the camera.
6. Insert the end of the ground wire into pin 1 (see Figure 7) of the Phoenix
plug as far as it will go. The plug has spring-cage connections and will grip
the wire.
7. Insert the end of the positive wire into pin 2 of the Phoenix plug as far as it
will go.
8. Insert the Phoenix plug into the terminal connector on the back of the
camera.
9. Connect a straight-through (patch) Ethernet cable to the RJ-45 connector
on the camera and to your network switch as shown in Figure 7.
10. Plug in or switch on the power supply.
11. When the connections are complete, go on to Section 5 on page 16.
Fig. 7: Camera Power Via a Terminal Connector
Network Switch
Straight-through
(patch)
Ethernet Cable
Gnd
+ DC In
Phoenix Plug
Pin 1
To Next Page
Loading...
