BAT glo HYPER+ - Instructions for Use; Charge; Charging Status

neo™ stick
Heater Chamber
glo™ Tobacco
Heater
EN EN
45
46
INSTRUCTIONS FOR USE
01 Charge
Insert the USB cable into the
USB charging port of the glo™
tobacco heater and connect
with a computer’s USB port
or USB AC adaptor.
The lights on the control
button will indicate the
charging status.
The glo™ tobacco heater may take up to 3.5 hours to be fully
charged at ambient temperature.
The glo™ tobacco heater can be used whilst plugged in as long
as it has enough charge. However, charging will be paused until
the session is complete. If the device is used whilst charging,
allow the device to cool for a minimum of 90s between
sessions.
02 Insert a neo™ stick
Slide open the shutter on top of the glo™ tobacco heater
and gently insert a neo™ stick until you feel the stick
touching the bottom of the glo™ tobacco heater. At this
point you should still see the top of the coloured collar
on the tipping of the neo™ stick.
Normal demi slim cigarettes will not work with the glo™
tobacco heater. Please only use neo™ sticks.
CHARGING STATUS:
Up to 25% charged
Up to 50% charged
Up to 75% charged
Up to 99% charged
100% charged