PAG 67 / 74
USER MANUAL NUMBER/VERSION: MU-001/4.0 DATE OF APPLICATION: 01/09/13
C/ R. Carrasco i Formiguera, 3
08192 Sant Quirze del Vallès [Barcelona - Spain]
T +34 935442003 F +34 902876503
www.batec-mobility.com info@batec-mobility.com
Checking the tyre pressure
Guarantee that the tyre pressure is between 2.5 and 3 BAR and no irregularities on the
surface can be seen.
Cleaning the BATEC:
Clean the chassis components with hot water and soap, car soap or a gentle non-
abrasive cleaner. Dry off any excess water.
Sand and sea water can damage certain parts of the
BATEC if they remain in contact for an extended period of
time. Clean it after using it.
Cleaning of front and rear wheels:
Ensure that the front wheel and the small rear wheels can turn freely and remove any
dirt.
Checking screw tightness torque:
Check that the screws and connections are tight. The recommended tightening torque
for the screws is:
• M5 screws: 7 Nm
• M6 screws: 10 Nm
• M8 screws: 15 Nm
To Next Page
Loading...