C/ R. Carrasco i Formiguera, 3
08192 Sant Quirze del Vallès [Barcelona - Spain]
T +34 935442003 F +34 902876503
www.batec-mobility.com info@batec-mobility.com
Checking brakes:
Check that when the brakes are activated, both press the disc enough to achieve
efficient braking.
Lubrication of wires and chainset:
Apply a drop of lubricant or lightly spray with teflon the wires that are in contact with
levers and the chainset. Clean off any remains of previous oil beforehand. Once you
have applied the oil, remove any excess.
Lubrication of transmission and connection mechanism:
Apply a drop of lubricant or lightly spray with Teflon the transmission and connection
mechanisms. Clean off any remains of previous oil beforehand. Once you have applied
the oil, remove any excess.
Servicing of the BATEC by an official service:
It is advisable to ensure your BATEC is in good conditon by taking it for full servicing
by trained staff.
Replacement of tyres and rubbers:
Before installing a new tube: Check that the base of the wheel rim and the internal
wall of the tyre have any external bodies and, if necessary, clean thoroughly. Check
the state of the rim tape; in particular the hole of the valve. Only a strong and properly
placed rim tape offers longstanding protection against damages in the tube caused by
burrs and pointy spoke heads.
Before inflating the tube, check the length of the contour of both sides to ensure that
the tube is not trapped between the tire bead and the wheel rim. Move away the valve
gently and remove it again, so that it is installed optimally.
To Next Page
Loading...