MVT26
October 2003 Section A Page 97
A.1.4 Approved Lubricants Chart
Unless otherwise specified in text, use the lubricants in Table 2.
A.1.5 Glossary of Abbreviations and Acronyms
† Available Only as Part of a Complete Assembly
AC Activated Charcoal, removes odor and taste
ACD automatic condensate drain
ASME American Society of Mechanical Engineers
CW clockwise
CCW counterclockwise
CGA Compressed Gas Association
DIN Deutsches Institut für Normung
DOT Department of Transportation
E1 single phase electrical supply
E3 three phase electrical supply
HP Chemical Catalyst, converts Carbon Monoxide to Carbon Dioxide
MS Molecular Sieve, removes moisture
NEC National Electrical Code
NEMA National Electrical Manufacturers Association
NFPA National Fire Protection Association
OSHA Occupational Safety & Health Administration
ODP open drip-proof (motor)
OEM Original Equipment Manufacturer
PCB printed circuit board
PMV pressure maintaining valve
SC Securus
®
Moisture Sensing Device
Usage Lubricants
O-rings, rubber and plastic parts; filter housing
threads, sealing rings
Parker Super “O” Lube
Bolts, nuts, studs, valve parts, copper gaskets and
tube connection parts (threads, cap nut and com-
pression rings)
Never-Seez NSWT, Pipe Dope or teflon tape
Paper gaskets DOW Corning 732 or equivalent silicon compound
applied on both sides before assembly,
High temperature connections DOW Corning 732 or equivalent temperature resis-
tant compound,
Tube connection ferrules, Never-Seez NSWT
Table A-2: Lubricant Chart
To Next Page
Loading...
