Page 16 For technical questions, please call 1-888-866-5797. Item 57001
SAFETY OPERATION MAINTENANCESETUP
General Operating Instructions
TO PREVENT SERIOUS INJURY WHILE IN OPERATION:
Use personal protective equipment. Always wear eye protection. Wear ANSI-approved
safety goggles with side shields. Grip the tool with both hands
1. Select an appropriate accessory
for the job. Install accessory.
2. Start the tool by pushing the Power Button.
3. Use the Variable Speed Dial to increase or
decrease speed. Use a speed appropriate to the
accessory and the material being worked on.
Reference the table in Recommended
Accessory Speeds on page 14
4. Apply the accessory to the work
material as needed.
5. When finished, stop the tool by pushing
Power Button. Wait for accessory to completely
stop spinning. Remove the accessory.
6. Store tool, parts and accessories in an
indoor dry area out of reach of children.
To Next Page
Loading...
