Page 9;&(%$*4.8"4,7%<'*#$"&8#=%/7*,#*%4,77%>?@@@?@AA?BCDC1Item 58339
EF;6GHIJ6KFGLIMNFLMG6MFMO6 E6GPJ
O.,83"83%S*7$%E'//&($%F##*5+7V%J&#"$"&8
The Sanding Belt Support Assembly can be used in a
horizontal or vertical position or at any angle in-between.
To change the Belt Support position, do the following:
1. Loosen the Belt Support Locking Screw
and raise the Belt Support Assembly to
the desired vertical position/angle.
2. After positioning, wrench tighten the
Locking Screw securely to prevent the
Belt Support Assembly from slipping.
S*7$%E'//&($%S*7$%E'//&($%
F##*5+7V%F##*5+7V%
T&4b"83%T&4b"83%
E4(*)
S*7$%
E'//&($%
F##*5+7V
;"3'(*%;
T*W*7"83%$.*%Q&(b%G,+7*
For accurate end sanding the Work Table
must be square to the Sanding Disc.
1. Place a combination square or framing square
(not included) on the Table so that the square
touches the Sanding Disc. If the Table is 90°
to the Sanding Disc, the Table is level. Always
maintain a maximum of 1/16" clearance
between the Table and the Sanding Disc.
2. If the Table is not 90° to the Sanding Disc
pad, loosen the Work Table Lock Knob
and tilt the Table until it is square with the
Sanding Disc. Tighten the Lock Knob.
Q&(b%G,+7*
E<',(*E<',(*
E,89"83%
U"#4
Q&(b%
G,+7*%
T&4b%
^8&+%
;"3'(*%R
U'#$%O&77*4$"&8%E*$'/
To minimize dust, the Sander is equipped with a Dust
Port for connecting to a dust collection system.
1. Connect a 2-1/2" dust collection hose from the
Dust Collection Port to a shop vacuum or dust
collection system (hose and system not included).
2. Periodically check the Dust Collection
Port for sawdust buildup that would
reduce the dust collection efficiency.
3. It is recommended to wear a dust mask or respirator
even when using a dust collection system.
;"3'(*%]
U'#$%
O&77*4$"&8%
J&($
To Next Page
Loading...
